| | |  | | Home » TETRA WHISP 60 & 100 REPAIR KT | | | | | | | Product Details: | | | Product Weight:
| 0.15 pounds | | Package Length:
| 4.65 inches | | Package Width:
| 3.62 inches | | Package Height:
| 1.26 inches | | Package Weight:
| 0.15 pounds | | Average Customer Rating:
|  based on 9 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 9 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
2 of 2 found the following review helpful:
 Whisper 60100 Aquarium Air Pump Parts KitJul 01, 2009
By J. Tate
The repair parts were exactly what I needed. Quick shipment helped me get my air pump working in no time.
1 of 1 found the following review helpful:
Too easy not to doMar 05, 2011
By K Mac
Eventually, if you take care of your aquariums & fish, you'll have to either rebuild or replace the all important air pumps. Replacing them can get expensive when dealing with the higher capacity pumps used on the 50 to 100 gallon tanks. Fortunately, if you chose to use the Tetra dome style air pumps, there are these excellent kits Tetra sells for rebuilding their pumps.
The rebuilding process is not complicated. If you can tell which end of a small phillips/cross point screwdriver fits your hand then you can probably handle this task easily in a few minutes. After un-plugging the power and disconnecting the air hoses, simply unscrew the four case screws recessed into the base of the pump. Gently separate the top from the base. Pull out the old parts. They're pressed into place and will slide out with gentle tugging. Pay attention to the relative arrangement of the openings on the back plates of the old assemblies: the new assemblies will need to be oriented tha same way. Carefully slide in the new assemblies while being careful with the O-rings to ensure they seat in their grooves correctly.
The kits come with a new air filter pad, and I highly recommend replacing the old one at this time. Simply pull out the old one installed in the bottom of the pump housing and press in the new one that came in the kit.
Reassemble the top & bottom housing halves, attach the air hoses and plug the power back in. You now should have essentially a new pump thanks to these high quality little kits, and you will have realized a considerable savings compared to replacing the pumps with new units.
Good Rebuild KitSep 15, 2011
By Tom
Just installed this rebuild kit on my Whisper 60 pump. It was an easy install and it now works as good as it did when it was new. My fish are much happier now, Thanks!
Pump repair is cheap and easyAug 13, 2011
By G. Bender
"Airline Writer"
I've been repairing my own air pumps since I was a kid. It's very easy and the kits are cheap, especially compared with buying a new pump.
The instructions provided are simple and clear.
Order arrived early (!) and was correct. Five stars!
Easy fix, pump works as new.Feb 07, 2011
By Sergio L. Aponte
"Iron Monkey"
This was a VERY easy fix. Just 4 screws under the air pump, replace the parts included, and close it again. Didn't take over 10 mins, and the pump now works just like new. The repair kit is about 1/2 the cost of the pump on sale, so not bad instead of throwing another pump out. :-) And this pump (I have the 100) is very quiet, so is good for my living room tank.
See all 9 customer reviews on Amazon.com
| | |
|
